Greeblies For Sidepanels Arrived!

The 3D-printed greeblies arrived!

Had to cut off one row from the grill for it to fit:

Sprayed some parts "chrome":

And some parts silver/aluminum, grey and khaki (for the small nipples:

Went over the u-clips with a black wash, and a tad of rust-colored wash on some of the screws:

Drilled out a hole for the selectorswitch on the hero-panel and drilled out the knob and fastened it so it is functional:

Printed new dot-decals because the previous ones were too small and flawed:

Comparison with the old ones:

Transferred to a clear screen:

When I sealed the sheet with waterslide decals with clear laquer, some parts of the paper turned a yellowish hue.
I tried a few of the decals out, and they weren't discolored and worked out fine.



The panels in their current state, not much left:

Sadly I had bought the wrong kind of rectangular yellow LEDs to go behind the screen on panel #2, and will have to wait (up to two weeks) for replacements before I can finish it.